Table of Contents
Tighten and check the harness
First, put the harness the dog.
Tip: harness taking harness off, turn it inside out and gently slide it over the dog’s ears. This makes it more comfortable for the dog.
Please note the following:
1.
Neck size: The underside of the neck strap must rest on the sternum or extend no more than 1 cm beyond it.
2.
Sternum length: Pay attention to the chest strap of the harness. It should reach the end of the sternum, leaving 3–4 ribs behind the strap.
3.
Back length/angle: The back section must be long enough so that both chest straps run diagonally upward and backward, ensuring that the pulling force is optimally harness across the harness .
1.
2.
3.
Slider
Loop
2.
3.
4.
Adjusting the waist belt
1.
When the harness is adjusted harness , it should fit loosely—there should be enough room for two fingers on each side under the waist straps.
To adjust the waist straps, slide the outer strap through the slider.
2.
Once the correct length is set, check to make sure both waist straps are the same length. If they are not, adjust them accordingly.
3.
The slider should be pushed upward toward the buckle to avoid pressure points on the ribs.
4.
To properly stow the excess strap, first pull it through the loops, then fold it once or twice and pull the loop over the strap.
As a general rule, it is better to adjust the harness too loose than too tight.
Why is the harness adjusted harness ?
If the harness is adjusted harness tightly and the pull harness at an angle on the harness , the dog’s spine will twist, which is not good for the dog.
harness , if the harness is adjusted loosely (properly), harness can rotate harness to 8 cm before the pull is applied. This prevents the dog’s spine from twisting.
When the dog is walking, it makes a short shoulder movement; however, when trotting or galloping, the shoulder movement is long.
harness the harness is harness tight, the dog cannot move freely because its shoulder movement is restricted.
However, if it is adjusted loosely, the dog can move freely, even when trotting or galloping.
In addition, if the harness is too tight, the fur can chafe, leading to skin irritation or hair loss.
Correct application
1.
Under normal circumstances (e.g., when walking in the woods), the leash is attached to the rear ring of the dog’s harness. This distributes the pull evenly from the upper to the lower part of the harness, across the sternum.
2.
If you want to walk the dog on a short leash (e.g., in the city), you can attach one end of the leash to the front ring of the harness and the other end to the rear ring.
Important when holding the leash on a short leash:
This makes it easy to steer the dog—whether to the left, right, or to slow down.
3.
The leash should not be attached only to the front ring, as this can put pressure on the windpipe, just like a collar.
To the harness:
The Dog Fun Run Standard is designed for everyday use
Care Instructions:
The harness be washed in a laundry bag at 30°C in the washing machine or by hand.
Use a mild detergent, but avoid fabric softener, as it can have adverse health effects on your dog.
You can hang it up to dry.
The harness not be put in the dryer or ironed.
Safety instructions:
- Check the harness for damage harness use
- Never leave the dog tied up unattended
- If the harness is harness tight, it can cause tension in the dog
- The Dog Fun Run Standard is not suitable as a car safety harness
- The harness is not intended for 24/7 use
If you're unsure about sizing or adjustments, or if you have any other questions, we're happy to help and advise you—whether by phone, email, or in person.
E-Mail
